重慶升降平臺在使用的時候，要經常進行檢查、維護和保養，這樣不僅能延長液壓升降機的使用壽命，更主要的是能夠使其工作時發輝更大的威力。那么該怎么做才能延長其使用壽命呢？
1、當油路檢查完畢之后，就需要再看看四周的情況了，檢查一下螺絲或者是連接物，然后再看看螺絲或者是連接位置是否有松動；升降平臺廠家提醒大家，還需要看一看有沒有漏油或者是滲油的現象，及時解決，以免造成不必要的麻煩。
When the oil checked, you need to look at the situation around, and check the screw or a linker, and then see whether the location of the screws or loose connections; lifting platform manufacturers to remind everyone that there is also need to look at no oil spill or oil leakage phenomenon and timely solutions to avoid unnecessary trouble.　　
2、液壓升降平臺第一次使用時，當運轉滿100小時時應更換新潤滑油。在以后的運行中應定期檢查潤滑油的質量，對混入雜質或變質的潤滑油須及時更換，一般情況下，對長期連續工作的減速機每6-8個月更換一次，對每天工作時間不超過8個小時的減速機每10個月更換一次。
When the hydraulic lifting platform for the first time, when running over 100 hours should be replaced with new oil. After the operation, the quality of lubricating oil should be checked regularly for oil mixed with impurities or deterioration must be replaced, in general, long-term continuous operation of the gearbox replaced once every 6-8 months of daily working time is not more than eight hours of gear replaced once every 10 months.　
3、在超過了磨合期的期限之后，升降平臺廠家告訴大家，此時就需要進行第一次的保養了，在這個保養過程中，需要檢查油路，看看油箱中是否偶液壓油，如果有的話，看其量是否足夠，能不能達到升降的效果，如果不夠則需要再添加一些。
After more than a run-in period of the period, lifting platform manufacturers tell you, this time on the need for maintenance for the first time, in this maintenance process, the need to check the oil, and see whether the dual hydraulic oil tank, if any so, to see whether the amount sufficient, can achieve the effect of lifting, if not you will need to add some.
4、在添加液壓油時要按規定的牌號選擇合適的液壓油。以防液壓油產生化學反應使性能發生變化。 注意，要排除系統內的空氣。液壓油泵的吸油管口不得露出油面，吸油管路必須密封良好。
When you add hydraulic oil according to the provisions of grades to choose the right hydraulic oil. Hydraulic oil to prevent a chemical reaction change in performance. Note that to exclude air in the system. Hydraulic pump suction nozzle shall not expose the oil, the suction line must be sealed well.
5、對于升降平臺的滾輪、中間軸，軸承，臂架鉸軸等經常磨損的地方，如發現磨損嚴重及時更換配件，經常行的各部加注一些潤滑油，延長軸承使用壽命。
For regular wear and tear the place wheel lifting platform, the intermediate shaft, bearings, boom hinge shaft, if found serious timely replacement of worn parts, often filling some lubricant line ministries, extending bearing life.
6、盡量采用專人操作與管理，不是人員禁止查看、拆卸電器，也是為了避免意外事故的發生。
Try using hand operation and management, not professionals prohibit viewing, disassemble appliances, but also to prevent accidents from happening.